Tap Point: Additional "PRE" Option = TAP, PRE, POST, GROUP

Hi,

I’ve already joined ticket although it’s closed. It’s seeming that it’s not going to open again with my reply so I’m opening a new ticket:

I wish the channel to bus config could be like this: TAP, PRE, POST, GROUP.
I understand that changing the TAP Points from channel only to channel/bus basis would be a no-go but what if there would be a 4th option per bus on the send config page.

Szenario: The console is used as FOH and Monitor at the same time, and I don’t want to use up all my channels to have duplicated vocal channels for Monitoring. The reason is to keep it simple as possible and to react quick if there’s some changes during soundcheck. With duplicated channels I must do the routing always twice if a singer plugs into a different stage box etc.

With this scenario in mind my only options are TAP for vocalist’s bus and POST for all the Band mate’s buses:
Imagine the vocalists are playing with IEM and the rest using conventional monitoring. In a worst case the singer’s to quite on a particular part of a song, I must push the vocalist fader on FOH mix… which raise the chance in having feedback from one of the conventional monitors on stage.

Long story short: I don’t want to have monitor mixes depending on what I’m doing in FOH and also don’t want to deliver an almost uncompressed vocal signal to the other musicians monitor mix. So, the addition of PRE-Point would solve this without using up additional duplicated channels.

Thank You, with sugar on top :-)