BUS FEED CONFIGURATION (FW 3.0.5)

Hi everyone. Here’s some info on the new BUS FEED CONFIGURATION screen.

Go to the HOME screen of the desired bus and click on the CHANNEL/BUS/AUX grid in the center of the screen to open the BUS FEED CONFIGURATION screen.

This grid shows the INPUT channels, AUX channels and BUSES currently being sent to the selected bus.

Alternatively, go to the second processing block in a BUS and click on the BUS FEED section.

When a SEND is disabled, the corresponding cell in the grid is greyed out.

The BUS FEED CONFIGURATION screen allows you to select one, multiple or all the input channels, AUX channels, BUSES, MAINS or MATRICES that can be sent to the selected BUS, MATRIX or MAIN. The following settings can be applied to the selected channels:

• SEND MODE:

o KEEP: keep the existing setting

o TAP/PRE: send the send mode to TAP point (for input and AUX channels) or PRE fader (for BUS, MAIN or MATRIX)

o POST: set the send mode to POST fader

o GROUP: set the send mode to GROUP mode, disabling the send level.

• IGNORE CHANNEL MUTE (TAP ONLY): this setting applies only to sends in input and AUX channels in TAP mode

o KEEP: keep the existing setting

o SET OFF: disable the send when the source channel is muted

o SET ON: keep the send active even when the source channel is muted

• SEND PANNING:

o KEEP: keep the existing setting

o CENTER: set the SEND panning to the center position

o CH PAN: set the SEND panning to the same position as the channel panning. The SEND panning can then be adjusted independently.

o PAN LINK: link the SEND and channel panning

• SEND ENABLE:

o KEEP: keep the existing setting

o SET OFF: disable the send

o SET ON: enable the send

• SEND LEVEL:

o KEEP: keep the existing setting

o -∞ dB: set the SEND LEVEL to minimum

o -10 dB: set the SEND LEVEL to -10 dB

o 0dB: set the SEND LEVEL to 0 dB

Click on APPLY after doing the desired changes.